The air filter on a Troy Bilt snow blower is located near the base of the engine. It is usually sealed in a plastic housing and can be accessed by removing the plastic cover. The specific location varies slightly depending on which model you have, but it will generally be found just behind the starter…
If your Toro snow blower won’t stay running, the most likely cause is a fuel system issue. Check that there is enough fresh gas in the tank and make sure it’s not stale or contaminated. Next, check the spark plug for signs of wear and tear or damage. If it needs to be replaced, do…
If your Snow Joe cordless snow blower is not working properly, there are a few troubleshooting steps you can take to try and diagnose the problem. First, check that the battery is fully charged and that all connections to the battery are secure. If the battery appears fine, inspect for any blockages in both intake…
The air filter on a snow blower is typically located near the engine. It will usually be inside a small compartment that can be accessed by either lifting or removing a top panel, or unscrewing and removing an access door from the side of the machine. Once you open this compartment, you should see the…
Ryobi 40V Snow Blower Troubleshooting can be done by first checking the battery and making sure it is charged. Check the air filter to make sure it is clean and not clogged with debris or snow. If the spark plug looks worn, replace it. If there are any obstruction in the auger or impeller area,…
Powersmart snow blowers can encounter a variety of issues. Some common problems include clogs in the chute, ice buildup on the auger or impeller blades, and difficulty starting due to fuel or oil issues. To address these issues, you should first check for clogs and remove any debris from the chute if present. Additionally, inspect…
If your Husqvarna snow blower won’t start, the most likely culprit is a dirty spark plug. Start by inspecting the spark plug to make sure it’s clean and in good condition. If it needs replacing, replace it with an OEM part from a Husqvarna dealer or authorized service center. Next, check that the fuel has…
To turn off a Toro Snow Blower, first make sure the engine switch is in the “Off” position. Next, remove the spark plug wire from the spark plug and keep it away from any metal parts on the machine. Once this is done, turn off all fuel valves to prevent gas or oil spills. Then…